Important Hints
The VBar Version 3.6 has benn reorganized internally, mainly to optimize bank switching. This gives new locations (index)
for some parameters. This has been done to make some parameters non
switchable. There is no need to switch the direction of a servo in
flight via bankswitch.
All parameters with new locations are not set initially, and have to be
set by hand after the update. The recommended method is using the
button "Facotry Setup" in the main page to set a usable default
configuration. After that edit the parameters you have changed from the
default setup to the value it has before. So it may be a good idea to
write down the changed parameters before the update.
The fiollowing table lists all parameters, that have changed, and have
to be set separately. These are no longer changed on bank switch:
| Parameter |
Paremetercount |
| Aileron Sensor Reverse |
1 |
| Elevator Sensor Reverse |
1 |
| Rudder SensorReverse |
1 |
| Swashplate Servo Reverse |
up to 4 |
| Cyclic Calibration |
2 |
| Swashplate Servo Type |
1 |
| Tail Servo Type |
1 |
Please check all
settings very carefully before take off. If you have Questions, please
use the forum to ask them. Do not fly if you are not 100% clear that
everything is ok.
Please read the help files provided on almost all pages in the software. They are reachable via the "Help" Buttons.
Existing setup
files are not 100% compatible with this version, becuse the parameters
listed above are not included. Nevertheless these old files can be
loaded, if afterwars the listet parameters are cecked and eventually
changed as needed. We will provide new files shortly.
This update is virtually a new device because of a lot changes. The
sotware was tested extensively at the 3D Masters 2007 by the complete
mikado team. There are no known issues.